Blink 2 LED flasher using Arduino

Today we will make a 2 LED flasher using Arduino (UNO)

Usual we use a transistors circuit to make two LED flasher. This we will study programing C code on Arduino. It is easy to learn. Step to step by Chayapol. Lets go!

Define pictograms of LED blinking  working


Figure 1 Define pictograms,easy to understand

diagram programing Arduino


Figure 2 Set the diagram programing

Put code in programing


Figure 3 Put code in programing

Read also: DIY Flashing Bicycle LED Taillight Circuit

Then, we open the Arduino IDE software. Next,write the code below

CODE

void setup() {
  pinMode(13, OUTPUT);
  pinMode(12, OUTPUT);
}
void loop() {
  digitalWrite(13, HIGH);
  digitalWrite(12, LOW);
  delay(1000);
  digitalWrite(13, LOW);
  digitalWrite(12, HIGH);
  delay(1000);
}
Programing on Arduino-IDE


Figure 4 programing on Arduino IDE

And then, when you’re done. Press Ctrl+R to Compile. For check it.

Parts you will need:
Arduino
2X LEDs
2X 470 ohm resistor
jumper wires

2 LED flasher Arduino circuit connection


Connect the parts as Figure 5
Then, apply USB port to computers
Finally, Click to Sketch>Upload code to the arduino board.
We will see 2 LEDs alternately blink as Figure 6.

Blink 2 LED flasher circuit using Arduino

And video below

-First we set time delay is 1 S
-Second we set time delay is 0.1 S (LED flasher faster)
-Third we set time delay is 3 S (LED flasher slowly)

Related circuit: 1.5V LED flasher circuit using transistor, output one LED to 5 LEDs with only one AAA battery.

we can use Arduino to make a 2 LED flasher but we have to adapt the We can use Arduino to make two flsher lights, LED work light, which is controlled by the internal code Arduino. Good luck