Many electronics circuits and projects for learning in simple ways.

2 Light controlled tone generator circuits

These circuits is used to control audio with light. In simple transduction And the change of light. To control the tone.,we is recommended that three circuits, each circuits consists of a simple device. Suitable for studying the performance of optical sensors is LDR.

2 Light controlled tone generator circuits

Tone Generator Control with light using IC 555

This the Tone Generator circuit that interesting because of can control the sound has with the light. By use the integrated circuit NE555 be pillar equipment , which perform produce sound frequency in model Astable Multi vibrator or pulse generator. And use 25 ohm small-sized loudspeakers. For the equipment detects the light. I uses LDR because of be usable good easy and economize with. For tone sound use can fine C1 get. by many values , make the low voice but when the value is a little make tall sound goes up. The detail is other see in the circuit better.

Tone Generator Control with light using IC 555


Photo from Amazon

Audible Light Sensor using IC-741

This is audible light sensor circuit that is based the IC741 op-amp IC. This circuit light sensor one,these are use two LDRs for detector lower lightly.
The 741 is pulse oscillator generator output to small speaker. The VR1 have value 50k acts as to fine sensitivity of light sensor. The speaker use small size only because output has low current.

Audible Light Sensor using IC-741

Note: You can buy IC-741 here!

This Post Has One Comment

  1. warrin circuit of light it’s can be exist

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Close Menu