VHF Band 2 Radio Spectrum tuning

VHF Band 2 Radio Spectrum tuning approximately With 2N3819

Circuit : Andy Collinson
Email: anc@mitedu.freeserve.co.uk

This is a VHF amplifier for the Band 2 Radio Spectrum tuning approximately 88 – 108 Mhz.

The circuit uses two 2N3819 FET’s in cascode configuration. The lower FET operates in common source mode, while the upper FET, operates in common gate, realising full high frequency gain. The bottom FET is tunable allowing a peak for a particular station. Coil details follow:

L1 4 turns of 18swg air spaced with a 1cm diameter, the tap is one turn up from earth end…
L2 4 turns of 18swg air spaced with 1 cm diameter. The coupling coil is 1 turn interwound from the supply end. Enamel coated wire must be used.

Source: http://www.zen22142.zen.co.uk/Circuits/rf/band2pre.htm

FM Radio by LA1800
3V superheterodyne FM receiver Read More Source:http://www.asahi-net.or.jp/~hp6y-isym/100radio.htm Related Links More FM Receiver circuits More RF Modulator circuits Pocket FM Radio circuits FM Receivers by TL431 - 2N4416 25W RF amplifier by BLY88 RF Preamplifier by 2N2219a , 2N ...
SW RF Pre-Amplifier with 2N3819
A radio frequency amplifier to boost SW reception. Frequency range approximately 5 to 20 MHz. Parts List: R1 100k R2 1k R3 330 R4 47k R5 68k R6 4.7k VR1 4.7k C1 100n C2 220p C3 100n C4 1n C5 10n VC1 500pF L1 2.5m J1 2N3819 Q1 BC108B The problem with amplifying weak ...
VHF Preamplifier 15-20 dB
The actual preamplifier in this circuit is a practical wideband amplfier that gives about 15 - 20dB of gain from 1.8 MHz through to well over 200 MHz. You will no-doubt replace this circuit for your own favorite amplifier for the band you are interested in. The 2.2mH chokes should have an ab ...
Wideband VHF/UHF/SHF 22dB PREAMP by MAR-6
The best place to put a pre-amplifier is with out a doubt as closest to the antenna as possible. If possible, directly mounted at the feeder (dipole) and using phantom-type powering of the amplifier. The RF/DC splitter comes inside the shack just before your receiver. Keep the connections as ...
Wide band high frequency amplifier
High-frequency amplifier circuit,Wide frequency band between 75-150 MHz,Using transistors, a PNP amplifier.To enhance the signal strength.Before the receiver of the phone. Or FM radio or amateur radio. If high-frequency signals, in particular, its VHF. The booster circuit is one, serves to ...