USB Li-ion battery charger by MCP73861
This is a charger for lithium ion batteries which takes its power from the USB port of a computer.
It uses the MCP73861 or MCP73863 Li-ion battery charger chip manufactured by Microchip.
Related Links
More Circuit about Battery
More Circuit about Battery Charger
More digital circuit
More Circuit about Li-Ion Battery Charger
Read More Source:
http://www.instructables.com/id/USB-Li-ion-battery-charger/
Thank you.
Related Posts :
This is a charger for lithium ion batteries which takes its power from the USB port of a computer. It uses the MCP73861 or MCP73863 Li-ion battery charger chip manufactured by Microchip. The circuit board is a piece of single sided copper clad board. A hole is cut inside it so that it will accom ...
This is a simple to build charger for single 3.7V lipo battery. The heart of the charger is TL431 shunt regulator that controls the incoming current. Charger comes with a convenient charging LED indicator. As charging current goes down so does the intensity of the LED. Read More Source:ht ...
The circuit's pretty simple, basicly it's just a voltage regulator. Both the LM317 and the REG1117A (LDO) fit the PCB, maybe there are even more types that I'm aware of that can be used on it. I did add one extra thing: a LED that shows if the connected device is consuming power. To do this ...
This is Dry Cell Battery Charger Circuit. That can use charger battery get that about 12 hour. When apply to power supply 9 volt the equipment that fix in the circuit use for size battery AA. If use the size C or D should devalue of Resistor RX down be 68ohm and should not lead ...
The charger in this project is designed to charge two AA NiMH or NiCd cells of any capacity (as long as they are the same) at about 470mA. It will charge 700mAh NiCds in about 1.5 hours, 1500mAh NiMHs in about 3.5 hours, and 2500mAh NiMHs in about 5.5 hours. The charger incorporates an autom ...
or 
