eeweb.com

Triangle and Squarewave Generator

Advertisement

Here is a simple triangle/squarewave generator using a common 1458 dual op-amp that can be used from very low frequencies to about 10 Khz. The time interval for one half cycle is about R*C and the outputs will supply about 10 milliamps of current. Triangle amplitude can be altered by adjusting the 47K resistor, and waveform offset can be removed by adding a capacitor in series with the output.

Source : http://ourworld.compuserve.com/homepages/Bill_Bowden/

Related Links
Oscillator Generator
Triangle wave generator
Squarewave Oscillator
More circuit by IC LM1458

Squarewave Oscillator by IC LM339
8038 Tri-Waveform Generator (Easy Oscillator Generator)
Waveform Generator with ICL8038
Triangle and Squarewave Generator

Related Posts :

  • This is circuit Function Generater,Triangle and Squarewave Generator. Use IC 40106 and Transistor BC547. VR1 For Control frequency Output. S3 to Seclector High = 1kHz-10kHz, Low = 10Hz-100Hz. Voltage supply 3-15V. Detail other see in circuit. Related Links Circuit More about Square ...

  • The circuit has both square-wave and triangle-wave output. The left section is similar in function to a comparator circuit that uses positive feedback for hysteresis. The inverting input is biased at one-half the Vcc voltage by resistor R4 and R5. The output is fed back to the non-inverting ...

  • Specifications Frequency range 0.95 Hz to 105 KHz in five decade ranges. Waveforms Sine, Triangular and Square. Output amplitude Adjustable from 10 mV PP. to 10 V PP Output impedance 50 ohms. Sine wave Amplitude Flatness +/- 1 dB Sine wave THD * Less than or equal to 0.8% from 10 H ...

  • This be Power Pulse Generator Circuit , by use the integrated circuit NE555 be Square wave Oscillator Generator. Fine the frequency done to a turn R1. From that time send output go to still transistor 2N2222 control give IC LM350T work have voltage come out the character pulse ...

  • This be Ramp Wave Generator Circuit by use UJT , 2N4891 numbers are important equipment. By Q2 take Voltage of C1 and give Output be sawtooth waves . The R3 will control occurrence waves sawtooth rate by signal picture has will the character is waves , the alms is Voltage quietly ...

Advertisement