Timer with buzzer and optocoupler by IC 4060

This small Timer circuit by sam(good electronic man).
sam say “A small circuit that can find a lot applications of measurement time. She has the possibility us inform with sound signal from the BZ1. At the same time, exist the possibility drive a external circuit via the optocoupler IC2, after we connect the applicable circuit in contacts [ A ] and [ B ]. The circuit is based on IC1 (4060), which include in his inside, oscillator and a binary divider of 14 stage. The frequency operation of oscillator is determined by a circuit R-C that connected in pins 9,10,11 of IC1. We give supply in the circuit, with switch S1,…”
About IC 4060

Read more : http://users.otenet.gr/~athsam/timer_with_buzzer_and_optocupler.htm

Timer Plus Relay by IC 555
This be Timer Plus Relay Circuit by IC 555. When see the circuit also a little equipment. By the value R1 and C1 perform set the time give Relay work 11 long ago second. When we begin to encourage the circuit by switch press 2 pin with a leg Ground note: Relay 6V 500ohm. Use current 12mA. ...
LM8560 Digital Clock 24 Hr with alarm
If do you want clock timer cicuit. I like this Circuit LM8560 Digital Clock 24 Hr with alarm. It is small and easy all in one pcb. I used IC LM8560 Digital Alarm Clock, 40 pin volttage supply 9V to 12V. I like it. circuit LM8560 Digital Clock 24 Hr with alarm PCB LM8560 Digital Cloc ...
Long Time Delays by CD4040
Generating long delays of several hours can be accomplished by using a low frequency oscillator and a binary counter as shown below. A single Schmitt Trigger inverter stage (1/6 of 74HC14) is used as a squarewave oscillator to produce a low frequency of about 0.5 Hertz. The 10K resistor in s ...
Relay Timer switch By IC 555 and 741
In Fig.1 see a 100 second delayed turn ON relay RL1 switch, if plug power +12V in circuit. In Fig.2 see a two range 6-60 second and 1-10 minute auto turn off relay timer circuit, with 555. Part R1=1 Mohms C4=100nF 63V IC2=LM555 R2=330 Kohms C1-2=100uF 16V RV1=470 Kohm ...
simple timer with IC 4093 + 7808
The on time of the timer is set by the one shot built with R2/R3 C3 and IC2A: after pressing pushbutton S1 C3 will be charged slowly through R3/R2; as long as the voltage of C3 is below the schmitt trigger trip level, the output of IC2A will be high and the the relay is switched on. Alt ...