eeweb.com

Time Delay Relay II by IC 4011

Advertisement

When activated by pressing a button, this time delay relay will activate a load after a specified amount of time. This time is adjustable to whatever you want simply by changing the value of a resistor and/or capacitor. The current capacity of the circuit is only limited by what kind of relay you decide to use.
Source:http://www.aaroncake.net/circuits/relaytim2.htm

Related Links
More circuit about Timer Switches
More circuit about Timer relay
More digital circuit
More digital integrated circuit design

More circuits by IC 4011
24 Hour Timer by IC 4060
Astable Timer with PIC 12F629 – 12F675

Related Posts :

  • A time delay relay is a relay that stays on for a certain amount of time once activated. This time delay relay is made up of a simple adjustable timer circuit which controls the actual relay. The time is adjustable from 0 to about 20 seconds with the parts specified. The current capacity of ...

  • This circuit can be used to delay other appliances connected to the output of the relay. After working set To prevent equipment damage from pressure. Surge. The IC number is 4011 Nand Gate CMOS .When switch S1 is current through R1. To charge at C1.This takes time to fully charge, and when ...

  • Generating long delays of several hours can be accomplished by using a low frequency oscillator and a binary counter as shown below. A single Schmitt Trigger inverter stage (1/6 of 74HC14) is used as a squarewave oscillator to produce a low frequency of about 0.5 Hertz. The 10K resistor in s ...

  • This be Timer Plus Relay Circuit by IC 555. When see the circuit also a little equipment. By the value R1 and C1 perform set the time give Relay work 11 long ago second. When we begin to encourage the circuit by switch press 2 pin with a leg Ground note: Relay 6V 500ohm. Use current 12mA. ...

  • This circuit provides a visual 9 second delay using 10 LEDs before closing a 12 volt relay. When the reset switch is closed, the 4017 decade counter will be reset to the 0 count which illuminates the LED driven from pin 3. The 555 timer output at pin 3 will be high and the voltage at pins 6 and ...

Advertisement