Temperature Monitor with IC LM741 or LM301

My Friend want circuit Temperature Monitor for control relay. I find on internet , See to This Web http://www.mitedu.freeserve.co.uk/Circuits good article circuit. The Temperature Monitor use CA741 circuits or IC 301 for test Temperature control relay switch.
read more detail:

Using a thermistor in the position shown makes a heat activated sensor. A change in temperature will
alter the output of the opamp and energize the relay and light the LED. Swapping the position of the
thermistor and 47k resistor makes a cold or frost alarm.

Temperature Window switch by IC 741
This circuit, is basically a resistance ï¿½ sensing window switch, except that the ï¿½resistorï¿½ takes the form of an NTC thermistor and the circuit thus responds to temperature. TH1 must have a resistance in the range 500ohm - 9Kohm. RV1 is used to set half ï¿½ supply volts on the RV1 ï¿½ ...
ICL7107 based, 4 channel digital thermometer
7107 is a old, good and versatile AD converter. I'm absolutely sure that 7106-7107 family will be in use since 2005 or maybe more... ( in Romania of course ) This four channel digital thermometer was designed for use in a car who hasn't board processor ( like our national car: Dacia 3xxx ). ...
Electronic Thermometer by LM35 and LM3914
As shown in the schematic, temperature sensor of our electronic thermometer is LM35DZ. There are some kinds of LM35 IC, since it is cheap and easy to find we used LM35DZ in our project. It measures from 0Â°C to 100°C with a very linear output graph.For one degree change, it increases its out ...
PIC Dual Temperature Meter by PIC16F628
This is extremely simple to build PIC Temperature meter that allows to measure temperature in two different locations at the same time. Never before such a useful and powerful circuit could be built with so little components and yet provide endless possibilities. This is all possible thanks ...
Frost Alarm or Cold Activated Switch by IC 741
A simple thermistor triggered cold switch with adjustable threshold. The thermistor used has a resistance of 15k at 25 degrees and 45k at 0 degrees Celsius. A suitable bead type thermistor can be found in the Maplin catalogue. The 100k pot allows this circuit to trigger over a wide ...