Stepper Motor Driver | Electronic Project Circuits

Posts Tagged ‘stepper motor driver’

Stepping Motor Driver using XNOR gate

The circuit is not particularly susceptible to motor transients and supports FULL STEPS FORWARD, FULL STEPS REVERSE, ACTIVE HOLD, and POWER OFF aka RELEASED. If the motor does not turn then swap around the leads of ONE of the two coils. To reverse the sense of the EN signal simply rework the circuit around an XNOR gate. [...]

ULN2003 Control Stepper Motor by Parallel Port

This is an easy to build stepper motor driver that will allow you to precisely control a unipolar stepper motor through your computer’s parallel port. With a stepper motor you can build a lot of interesting gadgets such as robots, elevator, PCB drilling mill, camera panning system, automatic fish feeder, etc. If you have never worked with stepper motors before you will surely have a lot of fun with this project.

Source:http://www.electronics-diy.com/stepper_motors.php

But This Stepper Motor Controller Connection Diagrams use 2 port voltage are 5Volt and 12V and four resistors , a zener diode.
The Four-Wire Connection the ULN2003 (High-Voltage High-Current Darlington Transistor Array
)/ MC1413 is a 7-bit 50V 500mA TTL-input NPN Darlington driver. This is more than adequate to control a four phase unipolar stepper motor such as the KP4M4-001.

Source: http://www.doc.ic.ac.uk/~ih/doc/stepper/control2/

EasyDriver Stepper Motor Driver ++ Free Shipping

Be the first to comment - What do you think? Posted by admin - May 15, 2008 at 12:34 pm

Categories: Circuit com, Electronic Control, Motor controller Tags: parallel port, stepper motor driver, ULN2003

Stepper Motor controller by PIC16F84

On these pages, I will introduce a control circuit for stepper motor. The software of this project is adapted to Embedded Systems(Lab13) for 2002 of Cleveland State University.
Source: http://www.hobby-elec.org/e_step.htm