Radio Remote Control Schematic | Electronic Project Circuits

Posts Tagged ‘radio remote control schematic’

Remote control using VHF modules

A few designs for remote control switches, using VG40T and VG40R remote control pair, are shown here. The miniature transmitter module shown in Fig. 1, which just measures 34 mm x 29 mm x 10 mm, can be used to operate all remote control receiver-cum-switch combinations described in this project. A compact 9-volt PP3 battery can be used with the transmitter. It can transmit signals up to 15 metres without any aerial. The operating frequency of the transmitter is 300 MHz. The following circuits, using VG40R remote control receiver module measuring 45 mm x 21 mm x 13 mm, can be used to: (a) activate a relay momentarily, (b) activate a relay for a preset period, (c) switch on and switch off a load.

Read More Source:http://www.radioland.net.ua/electronic-circuit-id-78.html
Thank you.

Be the first to comment - What do you think? Posted by admin - January 14, 2008 at 2:49 pm

Categories: Electronic Control, FM transmitter, RF-Radio Frequency Tags: radio remote control schematic, Radio-Remote-Control, vhf radio modules

Radio Remote Control using DTMF by UM91214 , KT3170

Here is a circuit of a remote control unit which makes use of the radio frequency signals to control various electrical appliances. This remote control unit has 4 channels which can be easily extended to 12. This circuit differs from similar circuits in view of its simplicity and a totally different concept of generating the control signals. Usually remote control circuits make use of infrared light to transmit control signals. Their use is thus limited to a very confined area and line-of-sight. However, this circuit makes use of radio frequency to transmit the control signals and hence it can be used for control from almost anywhere in the house. Here we make use of DTMF (dual-tone multi frequency) signals (used in telephones to dial the digits) as the control codes. The DTMF tones are used for frequency modulation of the carrier. At the receiver unit, these frequency modulated signals are intercepted to obtain DTMF tones at the speaker terminals. This DTMF signal is connected to a DTMF-to-BCD converter whose BCD output is used to switch-on and switch-off various electrical applicances.

Read More Source:http://www.radioland.net.ua/electronic-circuit-id-77.html
Thank you.