Contact: webmaster@eleccircuit.com
eeweb.com
Advertisement

Posts Tagged ‘plant moisture meter’

Salt-Taster by LM324

Detects the amount of salt contained in liquid foods
Three-level LED indicator

This circuit was designed to detect the approximate percentage of salt contained in a liquid. After careful setting it can be useful to persons needing a quick, rough indication of the salt content in liquid foods for diet purposes etc.
IC1A op-amp is wired as a DC differential amplifier and its output voltage increases as the DC resistance measured across the probes decreases. In fact, fresh water has a relatively high DC resistance value that will decrease proportionally as an increasing amount of salt is added.
IC1B, IC1C and IC1D are wired as comparators and drive D5, D4 and D3 in turn, as the voltage at their inverting inputs increases. Therefore, no LED will be on when the salt content of the liquid under test is very low, yellow LED D5 will illuminate when the salt content is low, green LED D4 will illuminate if the salt content is normal and red LED D3 will illuminate if the salt content is high.

Parts:
R1________________470R 1/4W Resistor
R2,R5______________10K 1/4W Resistors
R3,R6_____________220K 1/4W Resistors
R4__________________5K 1/2W Trimmer Cermet
R7________________680R 1/4W Resistor
R8__________________2K2 1/4W Resistor
R9,R10,R11,R12,R13__1K 1/4W Resistors
C1________________100µF 25V Electrolytic Capacitor
D1,D2,D3______3 or 5mm. Red LEDs
D4____________3 or 5mm. Green LED
D5____________3 or 5mm. Yellow LED
IC1_______________LM324 Low Power Quad Op-amp

Please read more at the original source:http://www.redcircuits.com//Page68.htm
Thank you.

Related Links
LM324 detector circuit
plant moisture meter
Liquid Level Controller

Moisture Activated Relay by Bipolar Transistor
Moisture Meter by 2N2222
Plant Moisture Meter by IC 741

Be the first to comment - What do you think?  Posted by admin - February 3, 2008 at 2:10 pm

Categories: Meter   Tags: , ,

Plant Moisture Meter by IC 741

Stick the metal probes into a freshly watered plant and adjust R5 for a mid-scale meter deflection. The meter will monitor the soil wetness and the meter will indicate whether it is to moist or to dry. This circuit uses a dual power supply which could be created by two 9 volt batteries.

Source : http://home.maine.rr.com/randylinscott/nov20.htm

Related Links
Plant moisture meter
Soil moisture meter
LM741 circuits

Moisture Activated Relay by Bipolar Transistor
Soil Moisture Meter
Metal Detector Circuit by BC548
Dew sensor by LM358
Moisture Meter by 2N2222
Plant moisture level monitor

Be the first to comment - What do you think?  Posted by admin - April 27, 2007 at 9:25 am

Categories: Basic electronics, Meter   Tags: , ,

Advertisement