Contact: webmaster@eleccircuit.com
eeweb.com
Advertisement

Posts Tagged ‘infrared circuit’

Infrared transmitters by LM3909

Infrared transmitters by LM3909

This is an infrared transmitters signal circuit that is small size and using a power supply 1.5V only. by main electronic part are two the LM3909 (a LED Flasher Oscillator IC) Normally, we tend to put it to use as a simple flashing light circuit. Using a 1.5V low power supply, it’s working now, Easier to use transistors. The high frequency, it is very simple, just change the device to high frequency only. C1 and R1 is lower the higher frequency.

Related Links
Infrared transmitter circuit
Infrared circuit
LM3909 led flasher ic

Infrared Transmitter by IC LM324
Infra Red Remote Control Extender by CA3140
Infrared Remote Control by Triac
IR Remote Control Modulation Detector

Be the first to comment - What do you think?  Posted by admin - September 30, 2011 at 6:02 pm

Categories: Electronic Control, Lighting   Tags: , ,

Remote control Encoder M145026

This encoder can generate up to 19,683 codes from 9 address lines by detecting 1,0, or open circuit. To initiate the transmit sequence, pin 14 should be pulsed low. The encoder will now output on pin 15 a data stream representing the condition on each of the address/data pins in turn and then repeat the operation, so that two complete identical words are transmitted. If pin 14 is held low, the output will be continuous, otherwise two identical words are output for each pulse on pin 14. A 1 is transmitted as two long pulses, a 0 as two short pulses, and an open circuit as a long pulse followed by a short pulse.

Read more :http://www.next.gr/inside-circuits/
Remote-control-Encoder-M145026B-1-l5876.html

Be the first to comment - What do you think?  Posted by admin - November 9, 2008 at 6:24 am

Categories: Electronic Control   Tags: ,

Simple Infra-Red Transmiter – reciever Shematics by IC4060

This 1 channel infrared transmitter/receiver remote control is the cheapest and simplest you can find. The transmitter transmits a sequence of pulses on 36 KHz frequency carrier. The diodes are Schottky type because of their low voltage drop (only 0.2V).

Read more :http://www.next.gr/inside-circuits/Simple-Infra-Red-Transmiter-reciever-Shematics-l4356.html

Related Links
More circuit about Infrared Circuit
More infrared switch
More circuit about IR Remote Control

Infra Red Switch control by normal remote
Infrared Remote Control
32 Channel IR Remote Controller by SL490

Be the first to comment - What do you think?  Posted by admin - November 3, 2008 at 6:43 am

Categories: Electronic Control   Tags: , ,

Advertisement

Next Page »