High Voltage Generator | Electronic Project Circuits

Posts Tagged ‘high voltage generator’

Ignition Coil High Voltage Generators

Below is the schematic to a high voltage generator using one ignition coil. It runs fine on 6 volts, but you can change the 5 relay to a 9 or 12 volt relay, and run it on 12 volts. The average output (depends on the coil, the input voltage, etc…) is 40kV.

Read more original source: http://www.geocities.com/mistertippy/schematics/ignition.html

Related Links
More Circuit about High voltage power supply
More circuit about high voltage generator
More circuit about Ignition Coil
Ignition coil driver by IC 555 + 2N3055
A flyback converter high voltage supply by 555
High-voltage circuits by 7555

Be the first to comment - What do you think? Posted by admin - July 3, 2008 at 2:41 pm

Categories: High current power supply, Power supply Tags: high voltage generator, ignition coil

Ignition Coil High Voltage Generator by SCR Trigger

When making the voltage doubler (if thats what your using, but this goes for every other option too) you should use photo flash capacitors. This is because they are designed for a rapid discharge. It is fine to use regular capacitors, but they could get hot, and even explode. For the heater, it can be anything like a toaster, oven, light bulb, iron, etc… You will need it, though, because when you trigger the SCR, its almost like your shorting out the power. If you leave this out you will throw a breaker, and probably destroy some components.

Read more original source:
http://www.geocities.com/mistertippy/schematics/ignition.html

Be the first to comment - What do you think? Posted by admin - June 30, 2008 at 2:14 pm

Categories: High voltage, Power supply Tags: high voltage, high voltage generator