High Volt Shock | Electronic Project Circuits

Posts Tagged ‘High volt shock’

High volt shock by transistor 2SC458

This the high voltage circuit pressure from the low beam in the character High volt shock. When switch S1 close the circuit for feed power supply give with Q1 and Q2. By current flow through coil of transformer of the primary and touch limit current with R1 and R2 already change come in pin way B of Q1 and Q2. It make Q1 and Q2 bias by transistor that bilateral alternate work all the time. When Q1 bias make have current flow change during a half on of coil primary and when Q2 make have current flow during a half below of coil primary. Which work alternation of Q1 and Q2 can make be the electric current alternates to come out at coil secondary cell building this circuit should use the carefulness. because of might born dangerous from the electric alternating current.

Be the first to comment - What do you think? Posted by admin - June 21, 2010 at 9:56 am

Categories: High voltage Tags: dc converter high voltage, high voltage, High volt shock

A flyback converter high voltage supply by 555

The circuit diagram of the flyback converter will hold no surprises (Fig.16). Literally the only difference with the boost converter is that the inductor is replaced by a transformer, and that the transistor has been replaced for a BUZ21. The BUZ21 has a much lower on resistance (Ron=0.085 ohm) as compared to the BUZ41A (Ron=1.5 ohm) but also a lower drain-source breakdown voltage (100V versus 500V).

Source:http://www.dos4ever.com/flyback/flyback.html
Thank you.