Dynamic Pre Mic | Electronic Project Circuits

Posts Tagged ‘dynamic pre mic’

Simple pre mic dynamic and Electrec condenser micro phone

This be simple pre mic circuit, that can can enlarge both of dynamic micro phone and , Electrec condenser micro phone. Then convenient for usable with small-sized stereo or the indoor.
By entering into power supply circuit LED1 will light showing the work of circuit conditions. The operation of this circuit has mic input 2 parts Electrec condenser micro phone and dynamic micro phone that it was Mike’s party that does not require power. When it come it passed to the C3 functions coupling capacitor signal filtering out only the signal to enter the B pin of Q1 amplifier to force up the signal output is exported to the C pin of Q1 and through C5 coupling signal edge again before leaving to the output of Electrec condenser micro phone as Mike used to cycle around beyond the required power supply flows through the it approximately 1 mA with R1 to limit current entering the Electrec condenser micro phone on the receiver. sound one. Signal to noise coupling through the C1 and C2 to have but a single voice.
Then the signal will be stretched out by Q1 and through the legs C C5 coupling signal before leaving to the output of R2 is organized as a bias feedback.
Signal from input to output stabilization in the work The output of the circuit is connected to a headset. Or may be connected to any power amplifier.

Be the first to comment - What do you think? Posted by admin - May 31, 2010 at 10:56 pm

Categories: Pre Amplifier Tags: dynamic pre mic, Electrec condenser micro phone

Dynamic Microphone Preamp Mono by Transister C945 (with PCB)

This circuit Dynamic Microphone Preamp,Pre MIC 3 Transister mono.
By Transister Part C945= 3 part.(TR1-TR3) OR C828 OR C458
Supply Volt 12V – 24V.
Easy to build and low cost.

Circuit Pre MIC – 3 Transister (C945) mono

PCB Pre MIC – 3 Transister (C945) mono

Be the first to comment - What do you think? Posted by admin - May 2, 2007 at 10:56 pm

Categories: Power Amplifier, Pre Amplifier Tags: dynamic pre mic, low noise pre mic, mic preamp circuit

Dynamic Microphone Preamplifier Mono by 3 Transister C945

This circuit Dynamic Microphone Preamp,Pre MIC 3 Transister mono.
By Transister Part C945= 3 part.(TR1-TR3) OR C828 OR C458
Supply Volt 12V – 24V.
Easy to build and low cost.

Circuit Pre MIC – 3 Transister (C945) mono PCB Pre MIC – 3 Transister (C945) mono