Contact: webmaster@eleccircuit.com
eeweb.com
Advertisement

Posts Tagged ‘audio mixer’

simple audio mixer circuit with fet 2n3819

This circuit, a simple mixer circuit.It can mix two signal channels and one channel is output.Using a codec circuit,Convert stereo audio to mono audio time.
It can increase the number of channels too. By adding a VR1, R1 and C1 to the amount needed. Then connected to Buffett a new one.Most importantly is eating circuit current is very low.Can use with 9-volt batteries immediately.
When entering voice signal, one of input 1 and input 2. Audio is via C1 and C2 of each channel,served coupling signals to VR1 and VR2. To adjust the audio to the Fet Q1.Which it serves, including audio. Then expand signal the output pin S through C3 For coupling signal again, before leaving to the output.

Related Links
See other circuit on audio mixer
See other circuit on fet amp
See other circuit on 2N3819

Audio Mixer by IC LF353
2-INPUT AUDIO MIXER by 2N3904
Mini Mixer by BC550C
Easy Audio Mixer by LM837

Be the first to comment - What do you think?  Posted by admin - September 13, 2010 at 11:22 pm

Categories: Audio diagram, Pre Amplifier, Tone control   Tags: , ,

Audio Mixer by FET 2N3819

This circuit be Audio Mixer Circuit by FET 2N3819 numbers, build easy and the a little equipment. By this circuit lets to use the microphone since two go up or use other tool all right wasp suit amplifier same microphone. The R1 and R5 will control value reduction input each beside. Thus R1 , and , R3 be the controller equilibriums.

Related Links Circuits
See other circuit on audio mixer
See other circuit on transistor audio mixer
See other circuit on transistor preamplifier

Audio Mixer by 2N3819 Junction FET
Stereo Mixer 4 Input by LF353
2-INPUT AUDIO MIXER by 2N3904
Mini Mixer by BC550C

Be the first to comment - What do you think?  Posted by admin - September 2, 2008 at 11:08 am

Categories: Pre Amplifier   Tags: , ,

Easy Audio Mixer by LM837

Easy Audio Mixer by LM837

The mixer itself is a fixed-gain summing amplifier based on an LM837. It sums up all the six microphone preamp signals into a single output. This is called the MIX OUT, and is a rear-panel socket. The single output is split into two outputs, to allow easy connection to external stereo equipment. The idea behind this is to allow connection of an external effects unit or graphic equalizer between the mixed output and the power amplifier.

Source:http://wiredworld.tripod.com/tronics/mixer.html
Thank you.

Related Links Circuit
More circuit about audio mixer
See other circuit on Audio mixer ic

Mini Stereo MIXER MIC-LINE for PC Audio Card
Stereo Mixer by LM353
2-INPUT AUDIO MIXER by 2N3904
Mini Mixer by BC550C

Be the first to comment - What do you think?  Posted by admin - February 11, 2008 at 2:31 pm

Categories: Audio diagram   Tags: ,

Advertisement

Next Page »