Switch-Mode LED Backlight by MAX1698

White-LED backlights are gaining acceptance because they offer higher reliability and simpler drive circuitry than those based on CCFL and EL technology. As a result, the white-LED backlight is increasingly common in PDAs, cell-phones, digital cameras, and other portable devices. A design in which the display is backlit (or frontlit) for extended periods needs an efficient circuit that drives the LEDs with a controlled current, and eliminates the wasted power associated with current-limiting resistors.

Read More Source: http://www.maxim-ic.com/appnotes.cfm/appnote_number/1871/ln/en
Thank you.

Very simple LED Flashing with sound
If we wasp one size miniature serial loudspeaker (8 ohm speaker) suits. Flashing LED number FRL - 4403 which be mourn shine that can can blink. By must not use other equipment help. unless , ...
Christmas Tree Lights Flasher with 7812+LM380
This is Circuit Christmas Tree Lights Flasher with 7812 for supply regulator and IC LM380 for Signal generator dirve relay on-off the lamp two set. detail other see circuit. The Christma ...
18 LED dimmable LED lamp by LM2941C
This circuit is a dimmable white LED lamp array with 18 LED Display. The lamp brightness is regulated as long as the input voltage is above 10.5V. A low-dropout analog voltage regulator is u ...
LED or Lamp Pulser with IC LM358
Astonishing effect 4.5V supply This circuit operates a LED in pulsing mode, i.e. the LED goes from off state, lights up gradually, then dims gradually, etc. This operation mode is obtained by ...
Power Flasher with MOSFET
Suitable for alerting purposes Drives 12V Car bulbs Derived from the Two-wire Lamp Flasher design, hosted on RED Free Circuit Designs since 1999, this astonishingly simple circuit allows one or t ...