Stepping Motor Driver using XNOR gate
The circuit is not particularly susceptible to motor transients and supports FULL STEPS FORWARD, FULL STEPS REVERSE, ACTIVE HOLD, and POWER OFF aka RELEASED. If the motor does not turn then swap around the leads of ONE of the two coils. To reverse the sense of the EN signal simply rework the circuit around an XNOR gate. [...]
Read more Source:
http://members.shaw.ca/novotill/StepperDriver/index.htm
Related Posts :
This is an example that demonstration how to control some devices via USB interface.The PC software program with delphi. Feature: - CPU PIC18F4550 with full speed USB interface at 48MHz. - USB ...
The UDN2540B is a quad darlington power driver, manufactured by Allegro. Each output can sink up to 1.8A continuous. The typical applications include print heads, relays, solenoids, and steppi ...
circuit was built to operate a small motor used for opening and closing a pair of curtains. As an advantage over automatic closing and opening systems, you have control of how much, or how littl ...
This circuit drives small DC motors up to about 100 watts or 5 amps or 40 volts, whichever comes first. Using bigger parts could make it more powerful. Using a real H-bridge IC makes sense for ...
This is an actual reverse engineered circuit diagram of the one transistor circuit most commonly used to drive Permanent Magnet DC motors in childrens' toys. This type of circuit almost always ...
or 
