Sound Switch Control with BC182B

Notes:
This sensitive sound operated switch can be used with a dynamic microphone insert as above,
or be used with an electret (ECM) microphone. If an ECM is used then R1 (shown dotted) will
need to be included. A suitable value would be between 2.2k and 10kohms.

The two BC109C transitors form an audio preamp, the gain of which is controlled by the 10k
preset. The output is further amplified by a BC182B transistor. To prevent instability the
preamp is decoupled with a 100u capacitor and 1k resistor. The audio voltage at the collector
of the BC182B is rectified by the two 1N4148 diodes and 4.7u capacitor. This dc voltage will
directly drive the BC212B transistor and operate the relay and LED.

It should be noted that this circuit does not “latch”. The relay and LED operate momentarily
in response to audio peaks.

source:http://www.zen22142.zen.co.uk/Circuits/Switching/soundsw.htm

Sound SCR Switch by IC 1458 & SCR C106D
This is Electronic Switch, Control by Sound. It is mini Circuit and easy, use IC 1458 or 4558 or LF353 , SCR for Switch Electronic = Relay Switch. Volt supply 9V. You can see LF353 in many circuits. Circuit Sound SCR Switch by IC 1458 & SCR C106D PCB Sound SCR Switch by IC 1458 & SCR ...
Control sound automatic by BC109
This circuit is the sound controls automatic circuit, by it will fix to don't give popularity level in the sound doesn't expire. When feed sound signal reaches in this circuit , as a result , will have a signal, will the power goes up to flow through LED shine to LDR. The connection and a r ...
Control signal Automatic Fader by LF351
This be Control signal Automatic Fader circuit , help fine decorate or control sound signal tallly or low follow want. In model the automatic convenient for the system electricity guitar , side sound of music work. By this circuit uses FET , then have tall rapidity , there is the crazy low ...
Hand Clap Electronic Control
We have all seen the commercial on TV .......... CLAP - ON - CLAP - OFF - THE - CLAPPER ............ well here is a circuit that will perform that same function. Circuit operation is as follows. A single hand clap will be picked up by the electric mic which is coupled through C1 into ...
Single Transistor Relay Toggle Circuit
The circuit below requires a double pole, double throw relay in conjunction with a single transistor to allow toggling the relay with a momentary push button. One set of relay contacts is used to control the load, while the other is used to provide feedback to keep the relay activated or deactiv ...