SG3525 DC Converter 12V to +35V,-35V

SG3525 DC/DC Converter 12V to +35V,-35V Switchmode Power Supply For Car Audio

The selected switching topology is called a “push-pull” converter, because the transformer has a double primary (or a “centre-tapped” one, if your prefer). The centre tap is permanently connected to the car battery (via an LC filter to avoid creating peaks in the battery lines, which could affect other electronic equipment in the car). The two ends of the primary are connected to a pair of paralleled MOSFETs each that tie them to ground in each conduction cycle (Vgs of the corresponding MOSFET high).

These MOSFETs should be fast, able to withstand high currents (in excess of 30A each if possible) and have the lowest possible Rds(on). The proposed On-Semiconductor?s MTP75N06 can withstand 75Amp and has a Rds(on) below 10 milliohm. This is important, because the lower this resistance is, the less power they are going to dissipate when switching with a square waveform. Another alternatives are MTP60N06, or the more popular BUZ11 and IRF540.

Although the schematics show a previous bipolar push-pull stage, you can also connect the gate resistor directly to the output of the controlling IC, leaving out the transistors, as the SG3525 is capable to drive up to 500 mA (theoretically), more than enough to switch the MOSFETs fast.

These MOSFETs should be fast, able to withstand high currents (in excess of 30A each if possible) and have the lowest possible Rds(on). …

Source:http://sound.westhost.com/project89.htm
Thank you.

DC12V to DC28V Converter with LM2585
This circuit is boost regulator, input volt DC12V for output DC28V (28v relay) The circuit is built around the LM2585, and uses the energy stored in an inductor to boost the 12v to 28. The c ...
POWER SUPPLY Switching 12V for CAR by SG3525
Switchmode Preamp Supply For Cars DescriptionThe extreme simplicity of this design is thanks to the circuitry inside the SG3525 controller IC. The two outputs have dual switching transistors, and ...
circuit dc to dc converter 12V to +/- 30V for car with IC SG3525
This is circuit Dc to DC Converter for Car Amplifier, Input 12V to Out +30V and -30V for Preamp or Power Amplifier. use IC SG3525 and Mosfet,Circuit Switching supply. I copy from forum ...
DC5V to DC30V Converter By 74HC14
Here is a power supply which makes about +30V from +5V power supply. The direct current is changed into the alternating current by the oscillator which used the schmitt trigger inverter whi ...
12V to 24VDC Voltage Booster
This circuit will double almost any DC input voltage as well as handling plenty of current. 12 to 24V is just an example. With a few changes, it can also supply any desired output voltage. ...