Sequential Brake/Turn Lights with IC 4094,7555

Bar-mode LED-cluster sequencer Can drive up to 16 clusters

This circuit, designed on request, allows up to 16 LED clusters illuminate in bar-mode sequence. LED sequencing will start when the Brake pedal is pressed (or Turn Lights are switched-on) and, when the last cluster illuminates, all LED clusters will remain steady on until the Brake pedal is released or Turn Lights are switched-off.

Parts:
R1,R5____________1K 1/4W Resistors
R2______________33K 1/4W Resistor
R3_____________100K 1/2W Trimmer Cermet
R4_______________1M 1/4W Resistor
R6,R7,R8________10K 1/4W Resistors
R9_______________4K7 1/4W Resistor
R10_____________33R 1/4W Resistor (See Notes)
[...]
D1______________LED (Any dimension, shape or color)
D2,D3________1N4002 100V 1A Diodes
D4–D15________LEDs High brightness, high efficiency red types (See Notes)
Q1___________2N3819 General-purpose N-Channel FET
Q2____________BC337 45V 800mA NPN Transistor
Q3____________BC547 45V 100mA NPN Transistor
IC1____________7555 or TS555CN CMos Timer IC
IC2,IC3________4094 8-stage shift-and-store bus register IC
SW1____________SPST Brake/Turn Lights Switch

Please read more at the original source :http://www.redcircuits.com//Page105.htm
Thank you.

Flashing brake lights
This circuit will allow the brake light was flashing.The default behavior. When the power supply to the circuit, Or tap the brake it.The IC timer IC2 drive current to transistor Q2 and produci ...
LED or Lamp Pulser with IC LM358
Astonishing effect 4.5V supply This circuit operates a LED in pulsing mode, i.e. the LED goes from off state, lights up gradually, then dims gradually, etc. This operation mode is obtained by ...
Fading LEDs with IC LM358
Two strips of LEDs fading in a complementary manner 9V Battery-operated portable unit This circuit operates two LED strips in pulsing mode, i.e. one LED strip goes from off state, lights up gr ...
Power Flasher with MOSFET
Suitable for alerting purposes Drives 12V Car bulbs Derived from the Two-wire Lamp Flasher design, hosted on RED Free Circuit Designs since 1999, this astonishingly simple circuit allows one or t ...
Strobe Light
The way that this circuit works is as follows. The AC line voltage is rectified by D1 and D2 which connects to a voltage doubler circuit made up of the two 22uf capacitors. The Flash Freq. Pot a ...