RF power amplifier 80W by C2782

This is a pretty conventional design, using bipolar transistors in a tuned class C circuit. Thanks to the use of two stages, the amplifier can be driven to full power with less than 1 watt driving power, so that a large gain margin results in this transmitter.

Bipolar VHF power transistors have a severe affinity for low frequency self-oscillation. To obtain stability in this amplifier, I employed several techniques, such as placing the resonances of base and collector chokes far apart, damping the chokes with resistors, using RC combinations for absorption of unwanted frequencies, using feedtrough capacitors for bypassing on the board, etc. It took some tweaking, but the amplifier ended up unconditionally stable.

The impedance matching network between the two transistors calls for such a low inductance, that it would be impractical to make it with actual wire. So I used a micro stripline etched on the PCB. Also, the power and SWR sensor at the output was made with micro striplines.

Read More Source:http://ludens.cl/Electron/fmtx/fmtx.html
Thank you.

1 Watt Universal RF Amplifier
This is a universal 1 Watt RF class C amplifier that is ideally suited for low power FM transmitters. Input should be at least 100mW to achieve 1W output. It is recommended to enclose the amplifie ...
Wide Band RF Amplifier for 10MHz - 500MHz Input by BFR540
This is a wide band amplifier cicuit which is suitable for the frequencies between 10MHz and 500MHz. Wide band amplifiers are used in communication receivers, RF measuring equipment and ton ...
RF power amplifier 87-108MHz 4-5W by 2SC1947
Here is circuit RF power amplifier, bands 87MHZ-108MHz power output 4-5W, Use top part is transistor 2SC1947. For FM Radio Transmitter. Supply Volt 12V only. Read more Source: http:// ...
60 WATTS LINEAR AMPLIFIER with IRF840
The 60 Watt linear amplifier is simple all solid state circuit using power mosfet IRF840. The IRF series of power transistors are available in various voltage and power ratings. A single IRF84 ...
FM Superregenerative Receiver
using only two transistors Building an AM receiver is a simple project for a beginner, but building an FM receiver is rather trickier. However, with a little ingenuity we can get away with a ve ...