Radio Remote Control using DTMF by UM91214 , KT3170

Here is a circuit of a remote control unit which makes use of the radio frequency signals to control various electrical appliances. This remote control unit has 4 channels which can be easily extended to 12. This circuit differs from similar circuits in view of its simplicity and a totally different concept of generating the control signals. Usually remote control circuits make use of infrared light to transmit control signals. Their use is thus limited to a very confined area and line-of-sight. However, this circuit makes use of radio frequency to transmit the control signals and hence it can be used for control from almost anywhere in the house. Here we make use of DTMF (dual-tone multi frequency) signals (used in telephones to dial the digits) as the control codes. The DTMF tones are used for frequency modulation of the carrier. At the receiver unit, these frequency modulated signals are intercepted to obtain DTMF tones at the speaker terminals. This DTMF signal is connected to a DTMF-to-BCD converter whose BCD output is used to switch-on and switch-off various electrical applicances.

Read More Source:http://www.radioland.net.ua/electronic-circuit-id-77.html
Thank you.

Remote control using VHF modules
A few designs for remote control switches, using VG40T and VG40R remote control pair, are shown here. The miniature transmitter module shown in Fig. 1, which just measures 34 mm x 29 mm x 10 mm, can be used to operate all remote control receiver-cum-switch combinations described in this proj ...
Remote control using telephone by KT3170
Here is a teleremote circuit which enables switching on and off of appliances through telephone lines. It can be used to switch appliances from any distance, overcoming the limited range of infrared and radio remote controls. The circuit described here can be used to switch up to nine applia ...
Single Channel RC Cars TX and RX
Simple RC Cars - Single channel Transmitters and Super Regenerative Receivers at 27MHz and 49MHz Here is the 9 volt GS transmitter which does not use a crystal. This clever design allows only two transistors to generate both the carrier and and the modulation. Shown below at 27MHz 40MHz and ...
Simple remote control tester circuit
When the remote control is not working, first check the battery before, It may be loss.If it is good,so detect transmit infrared light device.However, because the human eye can not see infrared light,so can not know how good or bad.But the photo transistor can use to detect infrared light. ...
RC5-RC6 codes on a LCD PIC16F628
Do you want to remote control the dim-level from the lighting, open and close the sun-blind and windows, turn the central heating on and off, and plenty more in your house with a normal TV remote control? Realize it with the projects underneath. Read More Source:http://www.picbasic.nl/rc5 ...