power supply regulator 0-28V 6A/8 Amp By LM317 and 2N3055| Circuit Project

This is an easy to make power supply which has stable, clean and regulator 0-28V 6A/8 Amp output voltage. By using two 2N3055 transistors we become more then 2 times the amount of amps then the power supply delivers, making it real though to brake . Although you could use this design to deliver 20 amps ((with almost no modifications and with a proper transfo and a huge heat sink with a fan), I did not needed such much power. Make sure you mount them on a huge heat sink, as the 2N3055 transistors can get very hot at full load.

Although the 7815 power regulator will kick in on shortcircuit, overload and thermal overheating, the fuses in the primary section of the transformer and the fuse F2 at the output will secure your power supply. The rectified voltage of: 30 volt x SQR2 = 30 x 1.41 = 42.30 volt measured on C1. So all capacitors should be rated at 50 volts. Caution: 42 volt is the voltage that could be on the output if one of the transistors should blow.
P1 allows you to ‘regulate’ the output voltage to anything between 0 and 28 volts. The LM317 lowest voltage is 1.2 volt. To have a zero voltage on the output I’ve put 3 diodes D7,D8 and D9 on the output of the LM317 to the base of the 2N3055 transistors. The LM317 maximum output voltage is 30 volts, but using the diodes D7,D8 & D9 the output voltage is approx 30v – (3x 0.6v) = 28.2volt.
Calibrate your build-in voltmeter using P3 and, of course, a good digital voltmeter.
P2 will allow you to set the limit of the maximum available amps at the output +Vcc. When using a 100 Ohm/1watt varistat the current is limited to approx. 3 Amps @ 47 Ohm and +- 1 Amp @ 100 Ohms.
By Guy, de ON6MU

Read More Source:http://users.belgacom.net/hamradio/schemas/6-20amps_regulatable_powersupplies_on6mu.htm
Thank you.

This entry was posted on Friday, August 10th, 2007 at 1:38 pm and is filed under high current power supply, LM317, Power supply, Variable Regulator.