OR gate with two IC 555
how to OR gate two 555, when one 555 cycles at a low frequency a valve turns on an off, the second 555 stretches the ON duration of the pulse with a diode OR gate, this OR output uses sample and hold to get the stable analog data from a sensor after the actuator has gone OFF, this ensures correct reading.
Read More Source:
http://schematics.blogspot.com/2004/10/
or-gate-with-two-555.html
Thank you.
Related Posts :
circuit Noise Gate by BC109, to filter audio sound,by Fet & Transistor (BC109).
This frequency doubler uses one CMOS quad, two input NAND gate package type 4011. The frequency doubler proper consists of an inverter IC1B, two differentiating networks R1/C1, R2/C2 and NAND gate IC1A, IC1C and IC1D function as input and output buffers. In Fig.2 exist the pulses in differen ...
This is very basic amplifier circuit,so I use IC digital Cmos 4011 quad NAND gate. It is to give equal to 10x linear amplifier. The resistor R1 = 1M ohm , R2 = 10M ohm. This circuit can not output speaker because it is very low power amplifier. Related Links Basic amplifier Digital ...
The circuit is not particularly susceptible to motor transients and supports FULL STEPS FORWARD, FULL STEPS REVERSE, ACTIVE HOLD, and POWER OFF aka RELEASED. If the motor does not turn then swap around the leads of ONE of the two coils. To reverse the sense of the EN signal simply rework the ...
Figure 1 represents a cheap and simple Gate Alarm, that is intended to run off a small universal AC-DC power supply. 4011 quad nand gate IC1a is a fast oscillator, and IC1b a slow oscillator, which are combined through IC1c to emit a high pip-pip-pip warning sound when a gate (or window, etc. ...
or 
