This is a very simple, low cost, Hi-Fi quality power amplifier. You can build it 5 ways, like it?s shown in the table (from 20 W to 80 W RMS).
Some comments:
- The first thing that you must do, is to measure the end transistors (T3 and T4) amplifying coefficient, the hfe or ?. If their disagreement is bigger than 30 %, the amplifier would not give a clear sound. I used MJ3001 and MJ2501 transistors, and this disagreement was around 5%.
- Before the first ?turning on? you must short circuit the inputs of the amp, and put a mA-meter on the output, than turn the amplifier on, and tune the R13 pot, to decrease the DC current on the output, to some uA-s, or in a lucky situation to zero. I was able to decrease it to 10 uA.
Copy from : http://www.electronics-lab.com
Thank you.
Related Links
30W Amp OTL by TDA2030 +Transistor
35W Amplifier BCL by TDA2030
40W Amp OCL 2N3055+MJ2955
Power Amplifier OCL 50W by 741+2N3055+MJ2955
50W Power Amplifier Mosfet
50W Power Amplifier OCL Mosfet (K1058 + J162)
This entry was posted on Thursday, April 19th, 2007 at 10:16 pm and is filed under Power Amplifier.
