Mini Power Amplifier 30W by TIP141 TIP146
Many times we needed a small power amplifier, but good quality, made from distinguishable components. The design does not have any innovation. In the power stage exist a pair of transistors Darlington in package TOP3, which can screwing on a heatsink, putting between them and in the heatsink, suitable leaves mica and silicone ointment on better temperature kidnapping. The bias current regulation becomes with the TR1, as follows. We place in terminally one from resistors R20 or their R21 multimeter binding post, in scale 200mV and we regulate late the TR1 until we take clue 12mV. This voltage dip (fall) corresponds in current 30mA. We thinly leave the amplifier in this regulation for 15 min. without signal in the input and check again. If it need we correct the regulation in 30mA.
R1=1Kohm R16-17=270ohm D1=9.1V 0.4W zener
R2=47Kohm R18=22ohm 1W D2-3=1N4148
R3=1.5Kohm R19=NC Q1-2=BC550C
R4-5=10Kohm R20-21=0.39ohm 4W Q3=MPSA56
R6=5.6Kohm TR1=250ohm trimmer Q4=BC547B
R7=10ohm C1=470nF 100V MKT Q5=BC212
R8=47Kohm C2=1nF 100V MKT Q6=BC183
R9=560ohm C3=68pF ceramic Q7-8=MPSAO6
R10-11=8.2Kohm C4-8=22nF 100V MKT Q9=TIP141
R12-15=120ohm C5-6-7=100nF 100V MKT Q10=TIP146
R13=680ohm C9=47uF 25V F1-2=1.6AT FUSE
R14=330ohm C10-11=220uF 63V All the resistors is 1/4W 1% except quote differently
Source:http://users.otenet.gr/~athsam/power_amplifier_30w.htm
Related Links
Small amplifiers
30 watt amplifier
Transistor amplifier schematic
24 Watt Class A Amplifier by 2N3055
Power Amplifier Class A 25W
Related Posts :
This circuit uses a high quality audio amplifier IC in a 5-pin TO220 package that does not require insulating washers between the metal tab and heatsink in single rail supply applications. The amp ...
A medium power amplifier that is characterized by a lot of good sound quality, but simultaneously is very simple in the construction. Him uses, enough time in my active loudspeakers. In his ...
This is circuit Power OCL Amplifier 35W , Use IC LM391 and is a complete driver of power transistors. Part R1-3-5-8-10=1Kohm C1=2.2uF 63V TR1=10K Trimmer R2-7-11=100Kohm C2=4 ...
This simple audio power amplifier was originally designed for a circuit board workshop, conducted by the OSU IEEE Student Group. At the workshop, 20 participants each constructed this amplifier, b ...
A ideal solution for the make a good, low cost power amplifier. It's a ideal solution for the creation a system of home cinema. The preamplifier and the driver support in a operational amplifi ...
or 
