Light to Frequency Converter TSL220

A large area photodiode and current to frequency converter combined in a clear plastic 8-pin DIL package. The output is a pulse train whose frequency is directly proportional to the light intensity. The output is CMOS compatible (use a 3k3 pulldown resistor to drive LS TTL) and the frequency can be measured by pulse counting, period timing or integration techniques. The photodiode has a wide dynamic range, high sensitivity and high noise immunity. The output frequency range is determined by a capacitor in the range 10pf to 100pf, which permits the output frequency to fall within some suitable range for any given light intensity.

Source: http://www.next.gr/inside-circuits/
Light-to-Frequency-Converter-TSL220-l5868.html

Low-Frequency Crystal Controlled Oscillator
The RF engineer sometimes has to look for an instrument that will check a low frequency quartz crystal unit reliably and rapidly. This is a difficult piece of equipment to find and the enginee ...
Pwm controller ic motor control circuit
I think about Pwm controller ic motor control circuit with a lot, so it is not easy to find. I created the following link. PWM Control Speed Motor 12V By TL494 This is circuit PWM Control Spee ...
Simulate the traffic light circuit
You would never suspect. Traffic jam at the intersection. He do? Has opened the green light and red light. Or to have people turn off. To resolve the question, we try to create this same circu ...
Voltage controls sine-wave frequency
The circuit in Fig 1 generates a 50-Hz to 1-kHz sinusoidal waveform that exhibits lower than 60-dB THD. The input voltage controls the output frequency with the relationship 1 kHz/V. The output am ...
Light to Sound Wave Receiver using IC 741
This be Light Wave Receiver circuit , perform take sound signal from the light by modify from the light into pieces hear at a loudspeaker. By the circuit uses LM741 , be IC op-amp the multi- ...