led display with nand gate digital control

This circuit operates in the digital circuit.It has 2 inputs are inputs inputs A and B inputs to receive input, By used nand gate ICs,To control the on-off of the lamp.

Operation of the circuit. When the input to the A is listed as “0″ or “1″.And B is listed as “0″ will cause the output of IC1 / 3 to “0″.The Q1 does not work will not light LED1.But if the A is listed as “0″ and B is listed as “1″ will cause the output of IC1 / 3 to “1″ As a result, Q1 LED1 light work.

But if the A is listed as “1″ and B is listed as “1″ will enable LED1 blinking frequency of approximately 3.5 Hz.The principle is working. The first two legs of the conditions IC1 / 1 “0″ to the output Into “1″.And IC1 / 2 off the output is “0″ IC1 / 3 to return to the status output from a “1″ LED1 is light.And caused a charge of C1.This will take and when will fully charge C1 pin 2 of IC1 / 1 is “1″ makes the output from “0″.And IC1 / 2 off the output is “1″ and IC1 / 3 to return to the status output from a “0″ LED1 is extinguished. And caused the discharge of C1 through the voltage of R2 through the voltage of C1 gradually decreased.The voltage at pin 2 of IC1 / 1 to 0 volts of this work will continue, causing LED1 flashes.

Digital : Other gates made with NAND
An important property of NAND gates is that they can be linked to perform the functions of other logic gates. In fact, any logic function can be implemented using only NAND gates: If you have des ...
Linear x10 Amplifier by 4011 Gate
This is very basic amplifier circuit,so I use IC digital Cmos 4011 quad NAND gate. It is to give equal to 10x linear amplifier. The resistor R1 = 1M ohm , R2 = 10M ohm. This circuit can no ...
On-off control SCR with logic gate IC
This is an SCR control circuit with digital logic. The behavior of the circuit. The input A to control current for SCR turn ON.The input B will stop the current SCR (OFF). Set the two input si ...
Basic Timer By IC Quad Timer LM558
Basic Timer By IC Quad Timer 558 Today I begs for to advise the circuit timer the foundation. By use the integrated circuit number LM558 (IC Quad Timer). Which the structure within like ...
Simple Touch Switch One Shot by 4011
Here is a simple touch control switch, I use IC 4011. Logic HI at output is timer pulse delay control by C1 1S = C1 4.7uF(micro farad), After touching the plate connected,so well pulse outp ...