LED 12V Lead Acid Battery Meter with LM339
In the circuit below, a quad voltage comparator (LM339) is used as a simple bar graph meter to indicate the charge condition of a 12 volt, lead acid battery. A 5 volt reference voltage is connected to each of the (+) inputs of the four comparators and the (-) inputs are connected to successive points along a voltage divider. The LEDs will illuminate when the voltage at the negative (-) input exceeds the reference voltage. Calibration can be done by adjusting the 2K potentiometer so that all four LEDs illuminate when the battery voltage is 12.7 volts, indicating full charge with no load on the battery. At 11.7 volts, the LEDs should be off indicating a dead battery. Each LED represents an approximate 25% change in charge condition or 300 millivolts, so that 3 LEDs indicate 75%, 2 LEDs indicate 50%, etc. The actual voltages will depend on temperature conditions and battery type, wet cell, gel cell etc.
Related Links Circuit
LM339 voltage comparator
More circuit about VU Meter
battery voltage checker
High impedance DC Voltmeter by IC CA3130
VU meter circuit for LM3915
Circuit basic dot-bar Display for LM3914
Lithium Polymer Voltage Monitor Circuit by LM10
Peak Reading VU Meter by IC CA3130
Peak Level Indicator by IC LM723
Related Posts :
The circuit below uses two quad voltage comparators (LM339) to illuminate a series of 8 LEDs indicating volume level. Each of the 8 comparators is biased at increasing voltages set by the vol ...
Circuit Peak Reading VU Meter by CA3130 When build power Amplifier Circuit finished already. Many you might something Peak Reading VU Meter circuits. I begs for to advise this circuit , ...
This is circuit Peak Detector voltage input, Use IC LF353 This be the circuit Peak Detector or checks pressure electricity topmost level is easily.Which I uses integrated number circuit LF ...
This is a simple light running circuit by music This circuit is not difficult, is MONO, with a few accessories. Can be connected to the output of a CD or cassette player Time. Operation of th ...
This is Circuit LM3914 LED VU Meter. use IC LM3914 and Transistor BC109C. For Display power Music by LED This be LED VU Meter by IC LM3914 circuit show with LED convenient for the stereo or ...






or

