LANTERN FLASHER – DIMMER by LM358

Basically a high-efficiency dimmer, but can also be used as a flasher. In dimmer mode, the LM358 (dual op-amp) is wired to send pulses at a constant frequency. By adjusting the width of these pulses, brightness of the bulb is controlled. In flasher mode, the same potentiometer is used to control the frequency – from about 1 to 20 flashes per second.

By lowering the brightness power consumption drops considerably, thus extending battery life. Flasher mode is even more efficient. This nice little circuit will work with any DC power supply/battery from 4.5 to 15V. A heat sink on the TIP32 power transistor should not be necessary.

Read More Source:http://www.geocities.com/tomzi.geo/index.htm
Thank you.

Dome Lamp Dimmer by LM358
There are times when a little light inside the car would greatly assist one of the passengers but the dome light is too bright for safe driving. The dimmer circuit in fig. 1 may be added to a ...
Light AC Dimmer 120Watt
This is Light AC Dimmer 120Watt circuit. It can use turn down a light bulb get to 120Watt. By fine decorate the brightness of a light bulb that at , VR1 , while , be usable , Triac hot then s ...
230V AC dimmer
Description: A reliable and efficient all-around performer. I bought the kit because it didn't cost me much more than the components were worth and I also got a nice professional-made PCB i ...
AC220V Light Dimmer 100W
This circuit has can to turn down a light bulb arrives at 100W. If Triac there is tall temperature should hold Heat Sink or let off the heat. The Diac be diode that perform be formed e ...
Dimmer or power control
You can use it with a bulb to vary brightness of bulb, this is a live circuit it can give a shock, enclose in plastic box, the pot should have a plastic knob, use a fuse, you can also use it f ...