JDM Programmer Modification by COM1
The JDM (or Ludipipo) seems to be among the most popular PIC programmers used – and rightly so: it is simple, cheap and easy to build, can be run with the free and excellent IC Prog software by Bonny Gijzen, and will program pretty much any PIC microcontroller on the market. However, an issue has arisen lately with some of the new PIC’s, eg PIC12F675, 12F629, and some others with an internal oscillator. When these chips are programmed the first time, everything goes fine. However, if you later try to read or re-write to them, they read as blank and cannot be written to. The problem only occurs when the PIC has been programmed for INTOSC and MCLR_OFF, but even in this situation sometimes it will re-program OK – there seems to be some other dependence on the program which has been loaded as well.
Read More Source:http://users.tpg.com.au/btkelly/jdm_b.htm
Thank you.
Related Links Circuits
More about programmer circuit
More about PIC Microcontroller
More circuit com
PIC Programmer
Related Posts :
This board can program an AVR microcontroler ATMEL (ATmega8, ATMega32, ...) from a parallel printer LPT1 using ISP functionality In System Programming. This programming type can program and/or ...
This multifunctional programmer for PIC microcontrollers will let you take advantage of their flexibility, reprogramming up to 1000 times to perform different functions, upgrade device firmwar ...
This programmer has been designed for use with a domestic heating boiler. It provides outputs via two relays to control the supply of Hot Water and Heating. There are 10 program entries availa ...
The following information was extracted from the September 1998 Electronics Now Magazine. The author of the article was Michael A. Covington. In Michael's article he acknowledges the contribution ...
The PIC 12F629 and 12F675 have a factory set oscillator calibration value written to the last program memory location during manufacture. When programming the PIC the programmer software should re ...
or 
