FM Transmitter with 2N2222

The range of the transmitter when running at 9V is about 300 feet. Running it from 12V increases the range to about 400 feet.

Parts
C1 1 0.001uf Disc Capacitor
C2 1 5.6pf Disc Capacitor
C3,C4 2 10uf Electrolytic Capacitor
C5 1 3-18pf Adjustable Cap
R1 1 270 Ohm 1/8W Resistor 270 Ohm 1/4W Resistor
R2,R5,R6 3 4.7k 1/8W Resistor 4.7K 1/4W Resistor
R3 1 10k 1/8W Resistor 10K 1/4W Resistor
R4 1 100k 1/8W Resistor 100K 1/4W Resistor
Q1, Q2 2 2N2222A NPN Transistor 2N3904, NTE123A
L1, L2 2 5 Turn Air Core Coil
MIC 1 Electret Microphone
MISC 1 9V Battery Snap, PC Board, Wire For Antenna

Read more Source:

http://www.aaroncake.net/circuits/fmtrans.asp

Thank you.

FM Transmitter 3W by 2N3553
This is the schematic for an FM transmitter with 3 to 3.5 W output power that can be used between 90 and 110 MHz. Although the stability isn't so bad, a PLL can be used on this circuit. Thi ...
AMPLIFIED CRYSTAL RADIO by LM386
An improved crystal radio with a two-stage audio amplifier. The 2N3904 (or any other general-purpose NPN) acts as a preamplifier while the LM386 boosts the signal high enough to drive low impe ...
FM Superregenerative Receiver
using only two transistors Building an AM receiver is a simple project for a beginner, but building an FM receiver is rather trickier. However, with a little ingenuity we can get away with a ve ...
VHF Test Transmitter
If you want to be independent of the local radio stations for testing VHF receivers, you need a frequency-modulated oscillator that covers the range of 89.5 to 108 MHz â€” but building such an osc ...
FM Stereo Transmitter with IC BA1404
You'll find that this is a very easy project to build. It will transmit good quality sound in the FM band ( 88 - 108 mhz ). One inportant item is that the IC chip operates on 3 volts DC. The chip ...