FM TRANSMITTER one Transistor by 2N3564, 2N5225
A truly minimalist circuit. Performance is relatively poor and stability is a problem. Q1 modulates the signal and acts as an oscillator. L1 and C5 determine the frequency. Decrease C5 for a higher frequency and vice-versa.
You won’t get a long range transmission with this one. The author claims 50-500 feet. A lot depends on the antenna. It must be made of stiff wire or else the frequency will change as you move the antenna. Experiment with different lengths to get the maximum range. 50cm or less should work reliably most of the time. A longer antenna might give even better range but if you exaggerate, the circuit will begin to oscillate and performance will drop dramatically. A regular telescope whip should work, too.
Part
R1 27k
R2 56k
R3 12k
R4 100
C1 1u
C2, C3 470p
C4 6 to 10p
C5 1-30p trimmer
L1 etched on PCB or a center-tapped coil 5mm in diameter, 6-8 turns of enamel-coated wire 1mm thick
Mic Electret microphone
Q1 2N3564, 2N5225 (other general-purpose NPN transistors will work, too)
Related Links Circuit
More about RF
More about FM Transmitter
FM Transmitter 4W by 2N3553
FM TRANSMITTER By 2N2222
FM Transmitter with Op-amp LM358
Coil-less FM Transmitter by IC 40106
FM Wireless Microphone
9 Volt FM Transmitter Kit by BC338
Simple FM transmitter with a single transistor by 2N2222
1.5W 1-2 km Range FM Transmitter by 2N2219
Read More Source:
http://www.geocities.com/tomzi.geo/index.htm
Thank you.
Related Posts :
This is Fm transmitter circuit for house. It is modulation type Mono FM and Frequency range 88-108 MHz. By it have Working voltage range 12-18 VDC and use current max at 450mA only. This circu ...
While there are a plethora of similar 2-transistor schematics available, this one is above average. A major improvement over the little 1-transistor circuit that we've discussed previously ...
This device can be very illegal if you attach an external antenna so don't. adjust frequency by turning trimmer. It is intended only as a practical joke device read more : http://www.next.g ...
The Circuit shown can transmit voice to exceptionally good range. Tune trimmer to hear the signal to your near radio. Frequency range is 88-108 MHz. Max current consumption is 30mA. You can power ...
This is a well designed basic FM transmitter that you can easily recive the signals transmitted from this transmitter in a 1-2km range with using a normal FM reciever. Another property of this ...
or 
