This circuit uses op-amps to obtain a triangle wave. The triangle wave causes the Led to slowly get brighter and then slowly get dimmer until it isn’t producing any light. It then gets slowly brighter again. With the components shown each cycle takes about 4 seconds. The capacitor and the 4.7M resistor are the timing components. The circuit works best when a high brightness Led is used.
…
Read More Source:http://www.geocities.com/electronics3456/fade.html
Thank you.
Related Links
More about fading led circuit
More circuit about LED Display
More circuit about led display warn
4011 Dual Led flasher
Two LED Flasher by Gate of IC 4011
Christmas Tree Lights Flasher with 7812+LM380
Super Flashing Light by C1061
Led Flasher LOW VOLT
Table Lamp Circuit by IC 555
2C cell LED Flashlight
This entry was posted on Friday, April 25th, 2008 at 8:11 am and is filed under LED Flasher, Lighting.
