Dry Cell Battery Charger using LM741 and IC4011 Reviewed by on . Rating:
You Are Here: Home » Battery & Charger » Dry Cell Battery Charger using LM741 and IC4011

Dry Cell Battery Charger using LM741 and IC4011

This is Dry Cell Battery Charger Circuit. That can use charger battery get that about 12 hour. When apply to power supply 9 volt the equipment that fix in the circuit use for size battery AA. If use the size C or D should devalue of Resistor RX down be 68ohm and should not lead battery come to serial while voltage in cell battery lower 1.6V. The Comparator Circuit with (IC741) control Gate output from Pulse Oscillator at use the integrated circuit CMOS 4011 change Transistor that do infront charger battery until voltage tall 1.6V Comparator Circuit more make LED Flasher warn know for protect Charger battery expire. The next time is if friends have Dry Cell Battery that use be finished already , don’t abandon , try apply new again yes.

Dry Cell Battery Charger using LM741 and IC4011

Other circuits are recommended.

  1. The most lead-acid battery charger circuit by LM317
  2. 12V Battery charger using UJT
  3. Best 12V battery charger circuit using LM311
  4. Automatic Battery Charger 6V-12V with Relay cut off by LM324




Comments (2)

  • Emilio

    Hello,

    I am trying to charge a 9 volt battery.
    What modifications would i have to make.
    Can you please describe the circuit in more detail too please!

    thanks!

  • mike

    can this charger charge 200ah, 13v and how many hours?

Leave a Comment

Copyright © 2015 www.eleccircuit.com

Scroll to top