Dark Activated Switch by IC 741

This circuit will activate a relay when light falls to a preset level. Light level can be adjusted with VR1 and the relay contacts may be used to operate an external light or buzzer.

Notes:
The light sensor used is the ORP12 photocell. In bright light the resistance of the ORP12 can be as low as 80 ohm and at 50lux (darkness) the resistance increases to over 1 Mohm. The 1M control should provide a wide range for light intensities, if not its value may be increased. The op-amp senses the voltage difference between pins 2 and 3. The control VR1 is adjusted so that the relay is off, the output of the op-amp will be around 2 Volts. When light falls, the resistance of the photocell increases and the difference in input voltage is amplified by the op-amp, the output will swing towards full supply and drive the transistor and relay. The 270k resistor provides a small amount of hysteresis, so that the circuit switches on and off with slightly different light levels. This eliminates relay chatter. Take great care if you decide to wire the relay to activate a mains lamp. Make sure the relay contacts provide adequate isolation and have ample rating for the load.

Parts List:
ORP12 Photocell (1) RLY1: 12VSPDT (1) U1: UA741 (1) Q1: BC109 NPN (1) D1: 1N4002 DIODE (1) F1: 1A (1) VR1: 1M RESISTOR (1) ORP12: 500K RESISTOR (1) R1,R3,R2: 10k RESISTOR (3) R5: 4.7k RESISTOR (1) R6: 1k RESISTOR (1) R4: 270k RESISTOR (1)

Circuit : Andy Collinson
Email: anc@mitedu.freeserve.co.uk
Source :: http://www.zen22142.zen.co.uk/Circuits/Switching/darksw.htm

Light Dark Detector Alarm by IC 555
Today we come to see the circuit detects the light by have a voice warn. When meet the light or be become dark depend on using S1 ( follow the circuit ). For this my circuit uses the integra ...
Mini switches controlled by light
Mini switch control circuits with light, by used the photo transistor is a light sensor, and Schmitt Trigger output drive current, Out a load or an external circuit,can supply up to 25 milliam ...
Light Relay Switch By BC547 & BC337
This circuit is simple form but can be useful various such as The alarm circuit, an more electronic control circuits such as ON-OFF electrical equipment, the flash light control circuit or etc. fo ...
Simple Darkness Activated Alarm by IC 555
Most darkness activated alarms employ opamps and some logic ICs. Here, a less expensive approach is shown based on the eternal 555, this time in monostable multivibrator mode. Components R2 an ...
12V 10A Dark Activated Switch by LM324
The circuit is a combination manual switch and automatic dark-activated switch. It is designed to control up to 10 amps of 12V lights. A pair of high-intensity white LEDs are included in the ...