CMOS 4013 Switch
The voltage generated by a piezo transducer can activate a digital circuit. One may build a simple demonstration switch from a piezo transducer and a 4013 D type flip flop (see Figure 12). Each time the piezo film is hit, it triggers the 4013 turning the LED on and off on alternate triggers. While this circuit works , it is unreliable, due to the waveform of the generated piezo pulse signal. To a digital circuit, a piezo-electric pulse will resemble a switch bounce with decay (see Figure 2).
Read more original source:
http://www.imagesco.com/articles/piezo/piezo07.html
Related Links
More circuit by IC 4013
More circuit switches
More about digital circuit
Digital gain control of Opamp
led display with nand gate digital control
4013 and IRF510 Easy drive a stepper motor
circuit 4013 Modula-8-Counter
circuit 4013 Divide by 2
Related Posts :
circuit 4013 Divide by 2 Related Links More circuits about IC 4013 More digital circuit More circuit digital counter More circuit about Frequency Divider More one shot More circuit ...
Here is easy circuit drive a stepper motor with pulse input. Use IC 4013 (IC Cmos) and Mosfet IRF510 drive Motor Stepper. The circuits below only required a single power source, The maxi ...
The basic digital circuits are Flip Flop and Counter, both are here. This circuit can be cascaded to make even a 6 digit event counter, even a simple frequency counter can be made. These are best ...
This circuit provides a visual 9 second delay using a 7 segment digital readout LED. When the switch is closed, the CD4010 up/down counter is preset to 9 and the 555 timer is disabled with the ou ...
The following CD4017 circuits have not been tested and is presented here as a possibility only. If you experiment with this circuit please send me any problems found so that the circuit can be up ...
or 
