Autoformer Switch-Mode Power Supply

This is a small 2*25 (actually, 2*50) WPC amplifier with 3-order crossover stage (configurable as LP or HP). Of particular interest is the unconventional autoformer PS arrangement. Since the power FET’s drains are not tied to ground anymore, it needs another transformer to drive gates. Gate driver is TL494 + MPSW56 followers, powered by REMOTE line.

The autoformer is small (25mm), windings are bifillar, single-strand 1.2mm wires. Both idle and full-load signal at secondaries is perfectly rectangular. 1:2 stepup results in 24V DC output (idle, unregulated). Idle draw is 1A @12V DC.

Read More Source:http://www.english.cxem.net/amplifier/amplifier55.php
Thank you.

555 timer as a switch-mode power supply
Most switch-mode power supplies rely on a PWM (pulse-width-modulated) output that is controlled via voltage feedback. A 555-timer IC can inexpensively perform PWM. The circuit in Figure 1 shows ho ...
5VDC to +12V and -12V Isolated dual Switching Regulator with LM2587
This circuit Dc converter step up voltage, For 5VDC to +12V and -12V Isolated dual Switching Regulator by IC LM2587-12V. Voltage supply input 4V to 6V, Output current 0.3A. Detail other see in c ...
5VDC to +12V and -12V Isolated dual power supply
This is circuit Isolated dual power supply OR DC to DC Converter Circuit. Input Voltage 5V,Output Voltage +12V and -12V. Detail: diode should be fast recovery type, for less than 100mA use 1 ...
DC5V to DC30V Converter By 74HC14
Here is a power supply which makes about +30V from +5V power supply. The direct current is changed into the alternating current by the oscillator which used the schmitt trigger inverter whi ...
Simple DC Converter For Digital Circuit by IC 555
This circuit Simple DC to DC Converter For Digital Circuit. It use Volt supply 5V Only, To Output Step up Volt 10V-12V DC max. I use IC 555 ( hot ic Timer) for Squarewave Oscillator to Driver mini ...