555 Timer 5 to 30 Minute

Circuit : Andy Collinson
Email: anc@mitedu.freeserve.co.uk

Descriptipn:
A switched timer for intervals of 5 to 30 minutes incremented in 5 minute steps.

Notes:
Simple to build, simple to make, nothing too complicated here. However you must use the CMOS type 555 timer designated the 7555, a normal 555 timer will not work here due to the resistor values. Also a low leakage type capacitor must be used for C1, and I would strongly suggest a Tantalum Bead type. Switch 3 adds an extra resistor in series to the timing chain with each rotation, the timing period us defined as :-

Timing = 1.1 C₁ x R₁

Universal Timer Kit

Note that R 1 has a value of 8.2M with S3 at position “a” and 49.2M at position “f”. This equates to just short of 300 seconds for each position of S3. C₁ and R₁ through R₆ may be changed for different timing periods. The output current from Pin 3 of the timer, is amplified by Q1 and used to drive a relay.

Versatile 12-Hour Timer with Cyclic Option (Fully Assembled)

Parts List:
Relay 9 volt coil with c/o contact (1)
S1: On/Off (1)
S2: Start (1)
S3: Range (1)
IC1: 7555 (1)
B1: 9V (1)
C1: 33uF CAP (1)
Q1: BC109C NPN (1)
D1: 1N4004 DIODE (1)
C2: 100n CAP (1)
R6,R5,R4,R3,R2,R1: 8.2M RESISTOR (6)
R8: 100k RESISTOR (1)
R7: 4.7k RESISTOR (1)
Source :: http://www.zen22142.zen.co.uk/Circuits/Timing/5_30timer.htm

Timer Plus Relay by IC 555
This be Timer Plus Relay Circuit by IC 555. When see the circuit also a little equipment. By the value R1 and C1 perform set the time give Relay work 11 long ago second. When we begin to en ...
simple timer with IC 4093 + 7808
The on time of the timer is set by the one shot built with R2/R3 C3 and IC2A: after pressing pushbutton S1 C3 will be charged slowly through R3/R2; as long as the voltage of C3 is below the ...
555 Asymmetric Timer
Circuit : Andy Collinson Email: anc@mitedu.freeserve.co.uk Description: A timer circuit with independent mark and space periods. Notes: A simple astable timer made with the 555, the mar ...
Long Time Delays by CD4040
Generating long delays of several hours can be accomplished by using a low frequency oscillator and a binary counter as shown below. A single Schmitt Trigger inverter stage (1/6 of 74HC14) is ...
Relay Timer switch By IC 555 and 741
In Fig.1 see a 100 second delayed turn ON relay RL1 switch, if plug power +12V in circuit. In Fig.2 see a two range 6-60 second and 1-10 minute auto turn off relay timer circuit, with 555. ...