50W Amplifier OCL with TIP33,TIP34

This is the power amplifier hifi ocl 50 watt, that I made with an all transistors. Because can reduce a noise signal very good, Natures sounds was helps to relax when listens for a long time and economical. Because the number of transistors old, inexpensive and easy to buy.
However, it also has some disadvantages that make it difficult when compared to the use of IC products.
From the circuit below. When we use a power supply +40 V and-40V will be about 50 watts RMS into 8-ohm speaker loads.
You can use the number of transistors used as BD249C, TIP33C, MJE3055, 2N3055 and BD250C, TIP34C, MJE2955, MJ2955 or a or Equivalent number.

This simple audio power amplifier was originally designed for a circuit board workshop, conducted by the OSU IEEE Student Group. At the workshop, 20 participants each constructed this amplifier, by etching and drilling the single sided circuit board, soldering all components, and attaching a pre-built heatsink assembly with the output transistors. Three workshops were held between 1995 to 1996. Though the design is simple, these amplifiers have impressive performance, with a frequency response to approx 40 kHz, very low noise, reasonably fast slew rate, and approx 50 watts (true RMS power) with the proper +/- 40 volt unregulated power supply.

Read More Source:http://www.pjrc.com/tech/cbw/index.html

Power Amplifier OCL 50W by BD250C , BD249C
This simple audio power amplifier was originally designed for a circuit board workshop, conducted by the OSU IEEE Student Group. At the workshop, 20 participants each constructed this amplifie ...
21W Class AB amplifier by TIP41
This is an instrument amplifier for monitoring music when on stage. It provides 21W output power of this little design. Previously I had a decent 10W amplifier (RED Free Circuits), but we blew ...
100W Audio Amplifier Transistor by BDW84 , BDW83
The circuit works from a symmetrical ±40 VDC power supply and draws a maximum current of 2.6 A. The input circuit of the amplifier is a differential amplifier built around Q4 and Q5 that emplo ...
14 watts audio amplifier with lm301 and tip2955-tip3055
The following circuit is a Audio amplifier which can give 14 watts of power. Feature : provide 14 watts of power, a discrete power op-amp, gain of approximately 150, preamp has voltage gain of ...
30W Class AB amplifier by TIP2955 + TIP3055
To set the above amplifier up, set R1 to max and R12 to 0. After doing this successfully, power on the amplifier. Set R1 so that the measured output offset is between 30 and 100mV. Once set, ...