500W HF linear amplifier

This is the circuit of a 500 watt linear amplifier, based upon a design by Frits Geerligs, PA0FRI, who has his own homepage at http://home.planet.nl/~fhvgeerligs. The circuit uses four PL519 TV line output valves in a very simple circuit that will deliver over 450 watts at 3.5 MHz (350 watts at 30 MHz). PL519 (40KG6A) is a more robust replacement for the earlier PL509 (40KG6) tube. Both valves will work well in this circuit. The input drive power is about 50 – 100 watts so it is compatible with most amateur radio HF transmitters. Not shown in the circuit is the cooling fan that is required to force air around the valves to cool them. In operation the 1K0 pot is adjusted to set the total valve anode current to around 50mA to 70 mA.

Read More Source:http://web.telia.com/~u85920178/tx/500w-txt.htm

100W FM AMPLIFIER by MRF317
This Power amplifier is equiped with a bipolar transistor,the famous MRF317 As lots of FM amplifier application ,the power transistor is in a C class bias. All the impedance networks (Input ...
1 Watt Universal RF Amplifier
This is a universal 1 Watt RF class C amplifier that is ideally suited for low power FM transmitters. Input should be at least 100mW to achieve 1W output. It is recommended to enclose the amplifie ...
60 WATTS LINEAR AMPLIFIER with IRF840
The 60 Watt linear amplifier is simple all solid state circuit using power mosfet IRF840. The IRF series of power transistors are available in various voltage and power ratings. A single IRF84 ...
Power Amplifier Transistor HiFi 1,500W 4 Ohms
Capable of 2kW peak and a minimum of 1.5kW continuous, it has to be said that this amplifier will blow up any speaker connected to it. Regardless of the claimed power that various drivers can ...
40 Watt Amplifier For FM Broadcast by MRF171A
This amplifier was built based on Marconi's website, A Design for a 40W broadband VHF RF Power Amplifier for FM broadcast. A few minor tweaks were made to the schematic and a few parts were change ...