50 Watt Amplifier with ICL8063 and 2N3055

This is a handy, easy to build general purpose 50 watt amp. The amp has an input for a radio, TV, stereo or other line level device. It also has a phono input for a record player, guitar, microphone or other un-amplified source. With the addition of a low pass filter at the input, it makes a great amp for a small subwoofer.
Description
R1 1 200 Ohm 1/4 W Resistor
R2 1 200K 1/4 W Resistor
R3 1 30K 1/4 W Resistor
R5 1 1K 1/4 W Resistor
R6 1 5K 1/4 W Resistor
R7,R10 2 1 Meg (5%) 1/2 W Resistor
R8,R9 2 0.4 Ohm 5 W Resistor
R11 1 10K Pot
R12,R13 2 51K 1/4 W Resistor
R14 1 47K 1/4 W Resistor
C1 1 100uF 35V Electrolytic Capacitor
C2 1 0.011uF Capacitor
C3 1 3750pF Capacitor
C4,C6 2 1000pF Capacitor
C5,C7,C8 3 0.001uF Capacitor
C9 1 50pF Capacitor
C10 1 0.3uF Capacitor
C11,C12 2 10,000uF 50V Electrolytic Capacitor
U1,U2 2 741 Op Amp
U3 1 ICL8063 Audio Amp Transister Driver thingy
Q1 1 2N3055 NPN Power Transistor
Q2 1 2N3791 PNP Power Transistor

Read More Source:http://www.projectecd.com
Thank you.

LM3876 - High-Performance 56W Audio Power Amplifier with Mute
The LM3876 is a high-performance audio power amplifier capable of delivering 56W of continuous average power to an 8 load with 0.1% THD+N from 20Hz-20kHz. The performance of the LM3876, utiliz ...
AGC Amplifier by mosfet
This amplifier does not have AGC applied. Two 100K resistors are used to set the gate 2 bias at approximately six volts, bypassed with a .01 decoupling capacitor. This amplifier may have a te ...
Mosfet Amplifier OTL 100W by K1058,J162
This includes a 220uF capacitor and two diodes to slow down the switch-on to reduce the output thump as the output capacitor charges through the speaker. This is not essential, depending on sp ...
Power Amplifier OCL 50W by Mosfet (K1058 + J162)
The 50W Power Amplifier OCL Mosfet (K1058 + J162) is easy to build, and very inexpensive. To use Power Supply +35V -35V at 2A. Power Mosfet (K1058 + J162) must be mounted on heatsink. Can be d ...
2N3055 Power Amplifier
Simple and low cost. The optimal supply voltage is around 50V, but this amp work from 30 to 60V. The maximal input voltage is around 0.8 - 1V. As you can see, in this design the components hav ...