50-300mW FM Transmitter by BC549

Here it is a brand new TX300 FM transmitter. The amplifier has exactly the same architecture as TX500 with the difference that TX300 has only one stage variable VHF amplifier. It is a cute schematic that was made for all of you who wanted something even simpler than TX500 and with not as many necessary parts. It is a perfect circuit for transmitting your music around the house and yard. Interesting feature is a gain control P1 that lets you adjust your desired output power and distance. If in case you want to replace Q2 with more powerful transmitter like 2n4427 or 2n3866 you will have to replace P1 with a resistor due to the higher necessary current. For much more info go to TX500′s page.

Read more Source:http://electronics-diy.com/tx300.php

500mW FM Transmitter by BC549
The TX500 is a simple to build 500mW FM Transmitter. It consists of three blocks; modulator / oscillator, two stage 500mW VHF amplifier and LED based power meter. The TX500 allows to transmit ...
VHF Test Transmitter
If you want to be independent of the local radio stations for testing VHF receivers, you need a frequency-modulated oscillator that covers the range of 89.5 to 108 MHz â€” but building such an osc ...
FM Wireless Microphone
Here is a very simple, inexpensive and interesting project which provides lot of fun to a home experimenter or hobbyist. This simple transmitter can transmit speech over a short range. It can be u ...
FM TRANSMITTER By 2N2222
There is a lot more to designing an FM transmitter, than meets the eye. Here is a typical FM transmitter circuit. It consists of 3 stages. An audio amplifier, RF Oscillator and RF output. ...
9 Volt FM Transmitter Kit by BC338
This new 9 Volt FM Transmitter Kit can transmit over 900 feet in the open depending on aerial used. The tank oscillator coil is built into the circuit board, and has been tinkered with to give th ...