4013 and IRF510 Easy drive a stepper motor
Here is easy circuit drive a stepper motor with pulse input. Use IC 4013 (IC Cmos) and Mosfet IRF510 drive Motor Stepper.
The circuits below only required a single power source, The maximum power supply voltage can not exceed +20V.
Read Source: http://home.att.net/~wzmicro/phasegen.html
Related Links
More Motor Speed Controller
More about drive stepper motor
More circuit by IC 4013
More circuit by IRF510
PWM Control Speed Motor 12V By TL494
PWM Motor Speed Controller – DC Light Dimmer by IC LM324
PWM Speed Motor Controller By IC 555
Stepper Motor Driver using L298 and L297
DC Motor Driver with L6203
PWM DC motor control with SG3525
Related Posts :
On these pages, I will introduce a control circuit for stepper motor. The software of this project is adapted to Embedded Systems(Lab13) for 2002 of Cleveland State University. Source: http ...
There are so many ways to drive a stepper motor, Here is another circuit that use 74LS194 4 bit bi-directional universal shift register as a phase generator and UDN2543B to drive the unipolar step ...
Stepper Motor Controller Connection Diagrams Four-Wire Connection The ULN2003 / MC1413 is a 7-bit 50V 500mA TTL-input NPN darlington driver. This is more than adequate to control a four phase uni ...
The transmitter circuit consists of WZ-X01 RF module, Holtek HT-640 encoder and 8-bit A/D converter. U1 ADC0804 converts the analog voltage to digital data; U2 encodes that data (D0~D6) along with ...
I found this circuit in my files. I don't know where it came from, but it looks like I photocopied it from somewhere years ago. I have been told that it came from "The Robot Builder's Bonanza", by ...
or 
