eeweb.com

3V FM Transmitter 88MHz to 108MHz by BF982

The important part of the circuit is formed of the Colpitts type oscillator. C3,C4,C5,C6,CD1-CD2 and L1 determines the frequency. BF982 and dual gate MOSFET are active parts in oscillator. When the input impedance of the MOSFET gate inputs are high, LC tank is not affected. However transistors force the LC tank and cause phase shift.

3V FM Transmitter  88MHz to 108MHz by BF982

Two driver stages are added to isolate the antenna from oscillator. First stage (BF199) ampifies the low signal of the oscillator and works as a constant load. The second stage (BFR90) amplifies the signal going through the antenna some more. A short copper wire can be used as an antenna here. Attaching a large antenna to this circuit is unnecessary because the output power is low.

Read More Source:

http://www.circuit-projects.com/

3v-fm-transmitter-for-short-distance-88mhz-to-108mhz.html
Thank you.

Related Links
More circuit FM Transmitter circuit
More circuit linear fm transmitter
FM Transmitter 4W by 2N3553
FM TRANSMITTER By 2N2222
FM Transmitter with Op-amp LM358
Coil-less FM Transmitter by IC 40106
FM Wireless Microphone

Related Posts :

  • The important part of the circuit is formed of the Colpitts type oscillator. C3,C4,C5,C6,CD1-CD2 and L1 determines the frequency. BF982 and dual gate MOSFET are active parts in oscillator. Whe ...

  • This device can be very illegal if you attach an external antenna so don't. adjust frequency by turning trimmer. It is intended only as a practical joke device read more : http://www.next.g ...

  • This is Fm transmitter circuit for house. It is modulation type Mono FM and Frequency range 88-108 MHz. By it have Working voltage range 12-18 VDC and use current max at 450mA only. This circu ...

  • While there are a plethora of similar 2-transistor schematics available, this one is above average. A major improvement over the little 1-transistor circuit that we've discussed previously ...

  • There is a lot more to designing an FM transmitter, than meets the eye. Here is a typical FM transmitter circuit. It consists of 3 stages. An audio amplifier, RF Oscillator and RF output. ...