15V Reducing Voltage Regulator Noise

The following circuit is designed for filtering 15 volt supplies like those typically found in instrumentation. The shunt will greatly reduce white noise, spurious signals, and line-related signals on the power supply; the attenuation can exceed 40 dB with careful construction. The values are not critical except that the gain of the amplifier should be very near the ratio of the transistor emitter resistor to the series shunt resistor. In this case the gain is 15/0.05 = 300. Actually the gain is 301 with the indicated values so a 299k resistor would be theoretically better but the resistor tolerances and the actual resistance in the 0.05 ohm shunt path will cause more variation. One of the gain resistors may be made variable to allow the performance to be tweaked for the deepest null, if desired. Choose a low noise metal foil or wirewound potentiometer for best results. Standard fixed values will give excellent noise reduction sufficient for most applications. The LM833 is an excellent choice but many other low noise op-amps will work well. Choose an op-amp with a high bandwidth and low input noise voltage. A higher value shunt resistor may be used if the voltage drop can be tolerated; adjust the gain of the amplifier to match as described above. The LM833 is a dual op-amp so two shunts may be implemented with the one package for filtering two different supplies or for cascading two shunts for additional line rejection and noise reduction. The noise shunt provides no load rejection beyond the rejection provided by the source regulator through the 0.05 ohm resistor.

Read More Source: http://www.techlib.com/electronics/finesse.html
Thank you.

circuit shunt regulator good quality by TL431
This is the Shunt Regulator circuitwith TL431 Voltage Reference - Shunt Voltage Reference IC. They is easy to used,comprises one IC, three resistors, four capacitors. if you like to use zen ...
Simple Regulator Circuits by JFET
This is uses an N-channel JFET as the pass element to achieve excellent line noise rejection and a bit of short circuit current protection but it is only suitable for light loads. Choose a JFET wi ...
Dual DC Regulator 15V using C1061 and A761
A friend of me you one take an interest a side Sound Audio the very. He takes an interest to want to build Pre tone Control which use the integrated circuit OP-AMP. By these circuit oft ...
Dual Variable Regulator power supply 5-25V by LM7805,LM7905
When you want Dual power supply Variable Regulator be simple. I begs for to advise this circuit, because use the integrated circuit LM7805 and IC 7905. Make have Voltage +5V to +25V ...
Filter the Scratch and Rumble Noise
If a friend gets into trouble about the noise. Try out this circuit before, may like. It is Filter the Scratch and Rumble Noise Circuit. That make a friend feels annoyed very the characte ...